![]() However, in general, you can add a switch to GNS3 by creating a new node, then selecting the appropriate template for the type of switch you want to add. There is no definitive answer to this question since it can vary depending on the specific requirements and setup of your GNS3 environment. ![]() Furthermore, campus technologies such as HSRP are supported as well. This tool supports a wide range of switching options, from unmanaged switches to Cisco IOS switches, to Nexus switches in data centers, to EtherSwitch modules, to emerging technologies like OpenFlow and SDN. Several of the capabilities provided by the GNS3 Ethernet switch include Ethernet switching (if that wasn’t obvious already), access VLANs (if that wasn’t obvious already), 802.1Q VLANs, and Stacked VLANs (if that wasn’t obvious already). Please feel free to comment at the bottom of this blog entry if you have any questions or have a topic you’d like to discuss with me. As you can see in the diagram below, it can even be used to mimic a multilayer switch. ![]() Inserting a NM-16ESW into a compatible router will allow you to use switch-like features in GNS3. Just be sure to select the right device type when adding the switch to your topology and you should be good to go. Overall, adding VLANs to an emulated switch in GNS3 is a fairly simple process. As such, you will need to make sure that the router you are using supports the features you want to use. Keep in mind that when you are configuring a switch in GNS3, you are actually configuring the router that is providing the switch emulation. This includes adding VLANs, setting up port trunking, and so forth. ![]() Once the switch has been added, you can then configure it as you would any other switch. In this case, you will want to select the “ Generic Switch” option. When adding a new switch to GNS3, you will be given the option to select the type of device you wish to add. This can be done in a couple of different ways, but the most common is to simply create a new switch and add it to the topology. In short, the answer is yes you can add VLANs to an emulated switch in GNS3. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |